Kismet Wireless

Kismet Forums

 

Posted by:actarus2003
Subject:can't read from Intel PRO2200BG
Date:16:05:04 14/09/2016

Hi,
it seem i can't read from my eth1 ntell PRO220BG Wireless/centrino interface

ERROR: Didn't understand driver 'ipw2200' for interface 'eth1', but it
looks like a mac80211 device so Kismet will use the generic options
for it. Please post on the Kismet forum or stop by the IRC channel
and report what driver it was.

lspci report
02:02.0 Network controller: Intel Corporation PRO/Wireless 2200BG [Calexico2] Network Connection (rev 05)

other server log tell
ERROR: Source 'eth1' failed to create mac80211 VIF: mac80211_createvap()
failed to create interface 'eth1mon'
ERROR: Source 'eth1' failed to set flags on VIF 'eth1': mac80211_setvapflag
failed to set flags on interface 'eth1': No such device
ERROR: pcap reported netlink type 1 (EN10MB) for eth1. This probably
means you're not in RFMON mode or your drivers are reporting a bad
value. Make sure you have the correct drivers and that entering
monitor mode succeeded.
ERROR: pcap reported netlink type 1 (EN10MB) for eth1. This probably
means you're not in RFMON mode or your drivers are reporting a bad
value. Make sure you have the correct drivers and that entering
monitor mode succeeded.
ERROR: Packet source 'eth1' failed to set channel 1: mac80211_setchannel()
could not set channel 1/2412 on interface 'eth1' err -10


I made something wrong or it is just wrong hardware ?

ciao


Reply to this message